© P
I
9
511472 (EN)
Heat Source Check
NOTE: This manual is only a supplement. Refer to
installation/operation manual for full instructions.
Electric Dryers
Close the loading door and start the dryer in a heat
setting (refer to Operation section). After the dryer has
operated for three minutes, the exhaust air or exhaust
pipe should be warm.
Gas Dryers
IMPORTANT: This operation is to be conducted
by qualified personnel only.
Electrical Requirements
NOTE: This manual is only a supplement. Refer to
installation/operation manual for full instructions.
Electric Dryers
Refer to serial plate for requirements.
SINGLE-PHASE MODELS
(230 Volt, 50 Hertz, 2 Wire Plus Earth, 30 Amp
Installation)
THREE-PHASE MODELS
(400/240 Volt, 50 Hertz, 4 Wire Plus Earth, 10 Amp
Installation)
NOTE: Refer to Kit 756P3 for Delta to Wye
conversion instructions.
To reduce the risk of serious injury or
death, the lower front panel must be in
place during normal operation.
W158
WARNING
To reduce the risk of fire, electric shock,
severe personal injury or death, all wiring
and earthing MUST abide with local
electrical codes. It is the customer’s
responsibility to have the wiring and
fuses checked by a qualified electrician to
make sure the laundry room has adequate
electrical power to operate the dryer.
W458
WARNING
To Next Page
Loading...
