Danube DD8 - Dryer Exhaust Requirements; Exhaust System Materials; Make-Up Air Requirements

©
I
13
511472 (EN)
Dryer Exhaust Requirements
NOTE: This manual is only a supplement. Refer to
installation/operation manual for full instructions.
IMPORTANT: Failure to exhaust dryer properly
will void warranty.
Exhaust System Materials
NOTE: Venting materials are not supplied with the
dryer (obtain locally).
Rigid metal duct is recommended. Non-combustible
flexible metal duct is acceptable.
Make-Up Air Requirements
A dryer exhausts 85 liters/second (180 cfm) (measured
at back of dryer) and sufficient make-up air must be
supplied to replace air exhausted by each dryer.
Figure 10
A clothes dryer produces combustible lint.
To reduce the risk of fire and combustion
gas accumulation the dryer MUST be
exhausted to the outdoors.
W116
This gas appliance contains or produces a
chemical or chemicals which can cause
death or serious illness and which are
known to the State of California to cause
cancer, birth defects, or other reproductive
harm. To reduce the risk from substances
in the fuel or from fuel combustion, make
sure this appliance is installed, operated,
and maintained according to the
instructions in this manual.
W115
To reduce the risk of fire and the
accumulation of combustion gases, DO
NOT exhaust dryer air into a window well,
gas vent, chimney or enclosed,
unventilated area, such as an attic, wall,
ceiling, crawl space under a building or
concealed space of a building.
W045
To reduce the risk of fire, DO NOT use
plastic or thin foil ducting to exhaust the
dryer.
W354
WARNING
D314I D315I
DO DON’T