Darex XPS-16+ - Page 13

10
Carbide Material
Curser Down
Curser Up
Page Down
Page Up
Move Sharpener Axis In
A Positive Direction
Move Sharpener Axis In
A Negative Direction
Hone Time Adjustment
Honing Wheel
Offset Adjustment
Honing Brush Edge Offset
Adjustment - X Axis
Honing Brush Face Offset
Adjustment - Z Axis
Wheel Position Offset
Wheel Edge Offset
Adjustment - X Axis
Wheel Face Offset
Adjustment - Z Axis
Split Point Offset
Adjustment
Position Stage For
Belt Change
Password Protected Area
Drill Stick-Out
Adjustment To Adjust
Facet Overlap
File Management
Sharpener (Inches) Active
Sharpener (mm) Active
Advance Selection
Auto Mode Selector
Manual Align
Mode Selector
Cancel Key
Save Key
Backspace
Delete File
Save
Open File
Relief Selection Screen
High Speed Steel Or
Cobalt Material Selector