4
Specific Safety Rules:
•
WARNING! ALWAYS use proper safety glasses. Everyday eyeglasses are NOT
safety glasses. Also use face or dust mask if operation is dusty. ALWAYS wear
certied safety equipment:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3)
• ANSI 512.6 (53.19) hearing protection
• NIO5H/OSHA respiratory protection
•
WARNING! Use of this tool can generate and/or disperse dust, which may cause serious
permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory
protection appropriate for the dust exposure. Direct particles away from face and body.
•
WARNING! This product contains a chemical known to the State of California to
cause cancer. Some dust created by power sanding and grinding as well as contents from the
machine may contain chemicals known to the State of California to cause cancer, birth defects
or other reproductive harm.
•
WARNING! Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lie on the skin may
promote absorption of harmful chemicals.
Safety Guidelines – Definitions
It is important for you to read and understand these Operating Instructions. The information it
contains relates to protecting YOUR SAFETY and PREVENTING PROBLEMS. The symbols
below are used to help you recognize this information:
•
DANGER! Indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury.
•
WARNING! Indicates a potentially hazardous situation which, if not avoided, could result
in death or serious injury.
•
CAUTION! Indicates a potentially hazardous situation which, if not avoided, may result in
minor or moderate injury.
•
CAUTION! Used without the safety alert symbol (
•
) indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
The label on your tool may include the following symbols:
V .................volts
Hz ............... hertz
min ............. minutes
............... direct current
............... Class II Construction
• ................
safety alert symbol
A ................. amperes
W ................watts
.............. alternating current
n
o
................ noload speed
rpm...............revolutions or
reciprocations per minute
To Next Page
Loading...
