46
APPENDIX 1
This document lists the event reporting codes for Contact ID reporting in the DL-250. The event codes are programmed by
placing a number from 0-15 in the "100's" location of the communicator code for the event being reported. The 10's and 1's
digit programmed are sent as the zone identifier. The following event codes will be sent for the digit programmed:
PROGRAMMED 100's DIGIT ADEMCO EVENT CODE DEFINITION
0 122 Silent panic
1 110 Fire
2 120 Panic
3 130 Burglary
4 131 Perimeter Burglary
5 132 Interior Burglary
6 133 24 hour Auxiliary
7 134 Entry/Exit Burglary
8 135 Day/Night Burglary
9 150 Non-burg 24 hour
10 121 Duress
11 100 Medical Alarm
12 123 Audible Panic
13 137 General Tamper
14 602 Autotest
15 354 Fail to Communicate
!!! IMPORTANT !!!
The following event codes are sent automatically but must be enabled by
programming a "1" in the communicator code location for that report:
REPORTING EVENT ADEMCO EVENT DIGIT LOCATIONS
Keypad Tamper 137 304
Autotest 602 308
Fail To Communicate 354 312
Box Tamper 137 316
A.C. Loss 301 320
Low Battery 302 324
Battery Test Fail 309 324
Restore Event code for alarm 332
Zone Isolate 570 334
Zone Trouble 380 336
Zone Tamper 137 / 144 339
Opening/Closing 401 340 / 341
Cancel 406 343
Late to Close 404 348
Early to Open 400 344
Download Complete 412 352
Expander Trouble 333 385
Wireless Sensor Tamper 137 / 144* 338
Wireless Tx Low Battery 384 Wireless zone Expander / Receiver
Wireless Tx Trouble / Inactive 381 Wireless zone Expander / Receiver
* If location 338 contains a "1", the event code will be 137. If location 338 contains a "2", the event code will be 144.
To Next Page
Loading...