9 Vantec series User's Manual
VANTEC-18A
The VANTEC-18A bass powered system (Class D amplifier) incorporates a 18” low frequency transducer with a 4" voice coil
mounted as a direct radiator into a bass-reflex cabinet. The loudspeaker is protected by a perforated steel grille, sealed
against corrosion using a powder coat finish. The VANTEC-18A is designed for use in biamped systems. A top located pole-
mount socket permits mounting full-range systems above the VANTEC-18A and two bar handles makes moving easy.
• Bass-reflex powered subwoofer system
• 18" low frequency transducer
• Precise and powerful bass reproduction
• Top located pole mount socket
VANTEC-215A
The VANTEC-215A is a powered loudspeaker (3 channel Class D amplifier), that utilizes two 15” bass loudspeakers for extra
low frequency punch and higher SPL in a “dual band” configuration where each speaker works in a specific frequency
range. High frequencies are handled by a 1”exit compression driver with titanium diaphragm. The trapezoidal cabinet is
constructed using Birch plywood and protected with a hard-wearing black paint finish. Two bar handles and a steel grille
sealed against corrosion using a polyamide powder coat finish are provided. Rigging points provide a safe and simple way
to fly the VANTEC-215A cabinets.
• 3-way powered system
• 2 x 15" bass loudspeaker working in a “dual band” configuration (2.5 ways)
• Compression driver with titanium diaphragm
• Two steel-reinforced handles
Vantec Series | Introduction
To Next Page
Loading...
