Data Aire dap4 - Programming Units with Primary;Secondary Schedule

20
The alarm may be set to either yes or no. Press the Enter key to move the cursor from one alarm
to the next. Press the Up or Down key to change from Y (yes) to N (no).
Once selections have been made and with the cursor fl ashing in the title block, press the Down
key to see the next screen. The following message will be displayed (entries are for reference
only):
The alarm may be set to either yes or no. Press the Enter key to move the cursor from one alarm
to the next. Press the Up or Down key to change from Y (yes) to N (no).
Once selections have been made and with the cursor fl ashing in the title block, press the Down
key to see the next screen. The following message will be displayed (entries are for reference
only):
Press ESC key to get back to main menu.
4.2 Programming Units with Primary/Secondary Schedule
See Section 1.1.1, Auto Lead/Lag Standby Rotation and Temperature Assist Logic for details
on unit rotation.
Once the choice of Primary/Secondary Schedule has been selected, the fi rst screen in the Set
Zone Master Menu will display as follows (entries are for reference only):
Zone Alarm Function 4
Stby Off
Override Sch Y N
Air Flow Y N
Water Flow Y N
Power-Up Y Y
Floor Water N N
Hum Inhibit N Y
Zone Alarm Function 5
Stby Off
Heat Inhibit Y N
Dirty Filter Y N
Alarm SW #1 Y N
Alarm SW #2 Y Y
Alarm SW #3 N N
Alarm SW #4 N Y
Zone Alarm Function 6
Stby Off
Manual Ovrd Y N
Hum Sensor Y N
RA Sensor Y N