25
7.0 CONTROLS
7.1 Standard Thermostat
The standard controls on all Mini Ceiling system equipment is a single stage cooling thermostat. Units
requiring optional reheat and/or humidifi er require the optional Mini DAP II control panel described
below.
7.2 Optional Programmable Thermostat
This optional thermostat is the same as the standard thermostat except it has some simple
programmable functions. This control cannot be used with optional reheat or humidifi er options.
7.3 Optional Mini DAP® II Microprocessor Control Panel
The Mini DAP II microprocessor control panel is available as an option. This control panel is required
when a unit has reheat and/or humidifi er options. There is a separate manual that goes into extensive
detail regarding functions, features, programming and troubleshooting.
The Mini DAP II microprocessor control panel has an entire manual dedicated to its use
and operation. This manual must be referenced to complete a thorough unit installation.
Start-up is not complete until the Mini DAP II control panel settings are established.
7.4 Optional Mini DAP® III Microprocessor Control Panel
The Mini DAP III microprocessor control panel is available as an upgrade from the Mini DAP II panel
and offers additional features including remote communications (with additional communication card
options). There is a separate manual that goes into extensive detail regarding functions, features,
programming and troubleshooting.
The Mini DAP III microprocessor control panel has an entire manual dedicated to its use
and operation. This manual must be referenced to complete a thorough unit installation.
Start-up is not complete until the Mini DAP III control panel settings are established.
7.5 Secondary Heat Exchangers
Most of the controls on remote condensers, condensing unit and fl uid coolers consist of basic
electromechanical type components. Secondary heat exchangers have separate installation and
operation manuals which give complete details on adjusting thermostat settings, etc. Refer also to
details in Section 3.5 within this manual.
To Next Page
Loading...
Need help?
General
