Calibration Settings
If this is your first time calibrating this display, you will automatically have Full
Calibration selected here. On subsequent calibrations you can choose doing a
FullCAL, a ReCAL, or a CheckCAL. A FullCAL will perform a full calibration of your
display. A ReCAL will recalibrate your display and a CheckCAL will check to see if
your display is still accurate.
You will also see your current target settings for Gamma, White Point, and
Brightness here. To make an adjustment to either of these targets, please choose
“Change Settings” in the lower left corner. Here you will also choose whether you
would want the Spyder to read your room light in order to help set the brightness of
your display properly based on the level of lighting in your room. Once you have
made your selections click “Next” to move onto the next screen.
To Next Page
Loading...
Need help?
General
