Display Analysis
This is a series of 4 tests you can perform on your monitor to see its strengths and
weaknesses. These tests can be accessed through “Shortcuts” dropdown or directly
from the Spyder5 program folder at /Support/Spyder5ProMQA. These tests
include:
Gamut
Graphs the display’s color saturation
Tone Response
Graphs the display’s tone response and white point
Brightness and Contrast
Brightness, Contrast and White point at different Brightness settings
White Point at Different OSD Settings
Brightness, Contrast and White Point at Different presets
Select the tests you wish to perform and then click “Begin Tests”. The software will
walk you through where to place the sensor and direct you when to change the
brightness on your display.
When performing the Brightness and Contrast test, the first portion of the test will
have you set your display to 0% brightness. Once you click the measure button it
will take about 10 seconds to perform the test. As your screen will be fully dimmed
it will be impossible to see when the test is complete, please wait about 10 seconds
before turning the brightness up a bit to continue.
Once finished, you can select “View Report” to see the results of all the tests.
To Next Page
Loading...
Need help?
General
