2 BATTERIES AND MAINTENANCE
NOTE
Rechargeable backup batteries and battery
packs are not initially charged. Therefore
the initial operation to perform is to charge
them. See below.
CAUTI
ON
Annual replacement of rechargeable
battery pack avoids possible risks or
abnormalities and ensures maximum
performance.
2.1 CHARGING THE BATTERY PACK
NOTE
The battery pack autonomy varies according to many factors,
such as the frequency of barcode scanning, RF usage, battery
life, storage, environmental conditions, etc.
The battery icon on the Taskbar indicates when the battery pack is low.
It is possible to recharge the battery pack by connecting the power supply directly to the Datalogic
FALCON™.
Alternatively, it is also possible to recharge the battery pack by using a Single Cradle or the Datalogic
FALCON™ Multi Battery Charger.
Moreover recharging is possible by USB Direct connection with the host computer, but with longer
charging times and only if the mobile computer is off.
During the charging process the LED positioned at the right side of the display is red constant. Once
the charging process has been completed this LED is green constant (see par. Error! Reference
source not found.).
If the battery pack is removed from the mobile computer, it can be recharged by inserting it into the
rear slot of a Single Cradle or the Datalogic FALCON™ Multi Battery Charger.
CAUTI
ON
Do not use the Datalogic FALCON™ until
batteries are charged for minimum 4 hours.
To Next Page
Loading...
Need help?
General
