Datalogic Falcon X3 Quick Reference Guide

3.2 CONNECTION TO USB PERIPHERALS
You can use a standard A (4 pin female) to mini A (5 pin male) USB cable to connect the Datalogic
FALCON™ to a keyboard or a memory. For all these devices maximum current withdrawal must be
below 100mA.
Key:
A Keyboard with USB
interface
C 94A051024 (Standard A to
Mini A USB cable)
B Datalogic
FALCON™
Key:
A USB hard drive/
external memory source
C 94A051024 (Standard A to
Mini A USB cable)
B Datalogic
FALCON™
NOTE
Connect first the USB peripheral to the cable, and then the cable
to the Datalogic FALCON™.
NOTE
Datalogic FALCON™ works with most of mentioned USB
peripherals. In any case, we can’t guarantee good operations with
all devices available on market place.
NOTE
Connection is compliant to 1.1 USB standard.
A
B
C
A
B
C

Datalogic Falcon X3 Specifications

General

RAM	256 MB
Flash Memory	1 GB
IP Rating	IP65
Operating System	Windows Embedded Handheld 6.5
Expansion Slot	MicroSD
Drop Resistance	1.8 m / 6.0 ft drops to concrete
Humidity	5 to 95% (non-condensing)
Supported Symbologies	PDF417, Data Matrix, QR Code
Operating Temperature	-10°C to 50°C (14°F to 122°F)