Datalogic Hand-Held Devices II User Manual

INITIAL SETUP
5
Successive start-ups will automatically recognize the previously loaded drivers. If
external power is used, verify that external power is already supplied.
NO
YES
Read test codes.
Reader is READY
LED blinks
LED off - BEEP OK
BEEP OK
Connect device to
Host with USB cable
Successive Start-Ups
Disconnect reader
at Host
Connect external
power supply to
cable and power up
Reconnect reader
cable to Host and
close dialog box
Does a dialog
box appear
asking whether
Bus power is
sufficient?

Datalogic Hand-Held Devices II Specifications

General

Brand	Datalogic
Model	Hand-Held Devices II
Category	Barcode Reader
Language	English