Datalogic Hand-Held Devices II User Manual

Enter Configuration Exit and Save Configuration
Ì$+;Î
DATA FORMAT
Ì$
-
?Î
53
C HARACTER R EPLACEMENT
 disable character replacement
ÌEO0mÎ
This parameter allows up to three characters to be replaced from the barcode read. These
substitutions are stored in memory. To define each
character replacement:
c
Read one of the following character replacement codes:
first character replacement
ÌEO1pÎ
second character replacement
ÌEO2sÎ
third character replacement
ÌEO3vÎ
d
From the Code Identifier Table in Appendix B, read the Code Identifier for the desired
code family.
0 = character replacement will be effective for all code families.
e
From the Hex/Numeric Table read two characters corresponding to the Hex value (00-FE)
which identifies the character to be replaced.
f
From the Hex/Numeric Table read two characters corresponding to the Hex value (00-FE)
which identifies the new character to replace.

Datalogic Hand-Held Devices II Specifications

General

Brand	Datalogic
Model	Hand-Held Devices II
Category	Barcode Reader
Language	English