Datalogic PowerScan PD9630-HP User Manual (English)

Other manuals for Datalogic PowerScan PD9630-HP

Questions and Answers:

S
sandovalchadAug 14, 2025
What to do if Datalogic PowerScan PD9630-HP LED is on but barcode does not decode?
- P
  Patricia CooperAug 15, 2025
  If the LED is on but the Datalogic Barcode Reader isn't decoding, consider these possibilities: * The reader might not be programmed for the bar code type you're scanning. Ensure it's properly programmed. * The bar code label could be damaged or unreadable. Check the label's condition and try scanning a different bar code. * The distance between the reader and the bar code might be incorrect. Adjust the distance by moving the reader closer or further away from the bar code.
M
Marc StricklandAug 17, 2025
How to fix Datalogic Barcode Reader when barcode is decoded but not transmitted to the host?
- J
  juan57Aug 17, 2025
  If the Datalogic Barcode Reader decodes the barcode but doesn't transmit it to the host, the reader might not be programmed for the correct host type. You should scan the appropriate host type bar code.
L
Lisa HarrisAug 21, 2025
What to do if Datalogic Barcode Reader LED is on but barcode doesn't decode?
- C
  connorrussellAug 21, 2025
  If the LED is on, but the bar code doesn't decode, it could be due to several reasons: * The reader might not be programmed for the correct bar code type. In this case, ensure the reader is programmed to read the type of bar code scanned. * The bar code label may be unreadable. Check the label to ensure it is not defaced. You can also try scanning another bar code type. * The distance between the reader and the bar code might be incorrect. Try moving the reader closer to or further from the bar code.
R
Ryan SosaAug 25, 2025
Why Datalogic PowerScan PD9630-HP does nothing when I pull the scan button?
- B
  Brandon MoralesAug 25, 2025
  If nothing happens when you pull the scan button on your Datalogic Barcode Reader, the issue might be due to: * No power to the reader. Check the system power and ensure the power supply is connected. * Loose interface or power cables. Make sure all cable connections are secure.