BATCH FEATURES ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
263
BATCH FEATURES
Batch Mode
This option specifies whether to store labels in the handheld while disconnected from
the base. Options are as follows:
• Disabled — The handheld will not store/batch labels.
• Automatic — The handheld will store labels to RAM when the handheld goes out
of range and is disconnected from the remote device.
• Manual — The handheld will always store labels to Flash memory. The user must
manually send the stored labels to the remote device using a special "batch send"
label.
Send Batch
When the reader is configured in Manual Batch Mode, use the following bar code to ini-
tiate sending of labels stored in batch memory.
Send Batch
BatchSend
$CBTBM00
Batch Mode = Disable
Batch Mode = Automatic
$CBTBM01
$CBTBM02
Batch Mode = Manual
NOTE: Do not scan an ENTER/EXIT PROGRAMMING MODE label in conjunc-
tion with this bar code.
To Next Page
Loading...
Need help?
General
