To Next Page

To Previous Page

ENTER/EXIT PROGRAMMING MODE 1D SYMBOLOGIES

148

POWERSCAN™ PD/PM96XX

I 2 of 5 Length Control

This feature specifies either variable length decoding or fixed length decoding for the I 2

of 5 symbology.

Variable Length: For variable-length decoding, a minimum length may be set.

Fixed Length: For fixed-length decoding, two different lengths may be set.

I 2 of 5 Set Length 1

This feature specifies one of the bar code lengths for "I 2 of 5 Length Control" on page

148

. Length 1 is the minimum label length if in Variable Length Mode, or the first fixed

length if in Fixed Length Mode. The length includes the bar code’s check and data char-

acters. The length can be set from 2 to 50 characters in increments of two. See "

Set

Length 1" on page 301

for more detailed programming instructions.

$CI2LC00



I 2 of 5 Length Control = Variable Length

I 2 of 5 Length Control = Fixed Length

$CI2LC01

Select I 2 of 5 Set Length 1 Setting

$CI2L1

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in Appendix D, Keypad represent-

ing your desired character(s). End by scanning the

ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL



Length 1 = 06 (6 characters)

Datalogic PowerScan PD9630-HP User Manual

Other manuals for Datalogic PowerScan PD9630-HP