Datalogic Magellan 1100i

© 2009 - 2013 Datalogic ADC, Inc 820061314 (Rev. B) November 2013
Magellan
TM
1100i
Fixed Mounting Plate Instructions
Securing the Fixed Mounting Plate
This sturdy plate can be used to mount the scanner in a number of
positions; either for new installations or to add to an existing system.
llaWpotretnuoC
Under Counter
New Installation
1. Determine the mounting location. The plate allows flexible, yet sturdy
mounting to a countertop, table, wall, or even under a counter. While
deciding on the best position, you might want to keep in mind the
best way to route the scanner cable (you may need to drill a hole for
it).
2. Using two of the screws provided in the kit, securely fasten them
d
own through the plate in the position desired.
BSR idware GmbH
Jakob-Haringer-Str.3
A-5020 Salzburg
Web: www.bsr.at

Datalogic Magellan 1100i Specifications

General

Yaw reading angle	-75 - 75 °
Decoding standards	-1D + GS1 DataBar, -GS1 DataBar Composites, -GS1 DataBar Expanded Stacked, -GS1 DataBar Stacked, -GS1 DataBar Stacked Omnidirectional, -MicroPDF417, -PDF417.
Tilt reading angle	0 - 360 °
Pitch reading angle	-65 - 65 °
Standard interfaces	USB, RS-232
Input voltage	4.5 - 14 V
Power consumption	400 mA
Dimensions (WxDxH)	84 x 71 x 94 mm
Product color	Black
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	198.5 g

Summary

Securing the Fixed Mounting Plate

New Installation Guide

Determine Mounting Location

Identify the best position for mounting the plate, considering cable routing and surface type.

Fasten Mounting Plate

Securely attach the plate to the chosen location using the provided screws.

Existing Installation

Scanner Latching and Unlatching

Latching the Scanner

Engage front latches, then rotate scanner rear down to secure it to the rear latch.

Unlatching the Scanner

Lift scanner rear to disengage rear latch, then lift the other end to release front latches.