PowerScan® M8300 Configuration
8 PowerScan® M8300
END of procedure. YOUR READER IS NOW READY TO READ CODES.
7.
Read the Bind code to pair the PowerScan
®
M8300 to the BC-80X0 cradle.
The reader is dedicated to the cradle. Any previously bound reader will be
excluded.
To connect several readers to the same cradle see the following section "Using
Multiple Readers with Same Cradle".
Bind
Ì$+RN0$-IÎ
The green LED on the PowerScan
®
M8300 will blink: the reader is ready to be
positioned onto the cradle.
8. Firmly position the reader onto the cradle within 10 seconds, a beep will be
emitted, signaling that the BC-80X0 cradle has been paired to the PowerScan
®
M8300, and the green LED on the reader will go off.
9. Configure the BC-80X0 cradle, refer to the “BC-80X0 Quick Reference”.
To Next Page
Loading...
Need help?
General
