PowerScan® M8300 Configuration
Quick Reference Guide 7
POWERSCAN
®
M8300/BC-80X0 STAND ALONE SETUP
When the BC-80X0 cradle is connected and powered, configure the PowerScan
®
M8300 by reading the following codes in the given sequence and follow the
instructions.
Note: for the numeric code selection of steps 3, 4, and 5 use the table at the end
of this Quick Reference.
1.
Restore PowerScan
®
M8300 Default
Ì$+$*oÎ
2. Enter Configuration
Ì$+;Î
3. Set Date
ÌIA%Î
+
six digits for Day, Month and Year (DDMMYY).
4. Set Time
ÌIB'Î
+
four digits for Hours and Minutes (HHMM).
5. Set Radio Address
ÌRA0RFHÎ
+
four digits for the PowerScan
®
M8300 Address
(from 0000 to 1999).
All readers used in the same area must have different addresses.
6. Exit and Save Configuration
Ì$-?Î
To Next Page
Loading...
Need help?
General
