Datalogic QuickScan QM2500

Operating Modes
QUICK REFERENCE GUIDE 27
★ = default value
OPERATING MODES
Scan Mode
The reader can be set to operate in one of several scan-
ning modes. See the PRG for more information and set-
tings for any of the following options:
Trigger Single (Default) This mode is associated with the
typical handheld reader operation. When the trigger is
pulled, illumination is turned on and the scanner attempts
to read a label.
Scanning is activated until one of the following occurs:
• the programmable Scanning Active Time
1
expires
• a label has been read
• the trigger is released
Trigger Hold Multiple - When the trigger is pulled, scan-
ning starts and the product scans until the trigger is
released or Scanning Active Time
1
expires. Reading a label
does not disable scanning. Double Read Timeout
1
pre-
vents undesired multiple reads while in this mode.
Trigger Pulse Multiple - Scanning begins when the trigger
is pulled and continues after the trigger is released, until
the trigger is pulled again or until the programmable Scan-
ning Active Time
1
expires. Reading a label does not disable
GREEN SPOT DURATION (CONTINUED)
Medium (500 ms)
Long (800 ms)
1. See the Product Reference Guide (PRG) for these and other pro-
grammable features.