Need help?Do you have a question about the Datalogic QuickScan QM2400 and is the answer not in the manual?
General| Brand | Datalogic |
|---|---|
| Model | QuickScan QM2400 |
| Category | Barcode Reader |
| Language | English |
Details how to connect the base station cables and secure them.
Describes different ways the reader and base station can be set up and connected.
Provides information on the radio base, including its LEDs.
Explains the reader's omni-directional scanning capability and aiming system.
Details the types of bar codes the reader can decode.
Explains how to secure the reader to the base station for electrical contact.
Describes the procedure for establishing a wireless link between the reader and base.
Instructions for powering down the handheld unit.
Introduces reader configuration and programming methods.
Explains how to use bar codes to reconfigure the reader's settings.
Instructions on how to restore the reader to its factory default settings.
Lists the host interfaces supported by the base station.
Details how to scan a bar code to select the correct interface type.
Explains how to select options for USB Keyboard and Wedge Interfaces.
Specifies the country/language support for keyboard interfaces.
Provides instructions on how to remove and install the battery pack.
Describes the reader's aiming system and its patterns for different bar codes.
Details the physical attributes of the reader and base station.
Covers battery type, charging time, and operating autonomy.
Outlines optical and physical performance parameters like angles and field of view.
Lists the typical depth of field for various symbologies.
Lists all supported 1D and 2D bar code symbologies.
Lists all compatible interface types the reader can use.
Explains reader indications for power-up, good read, errors, and active/disabled states.
Details the LED and beeper feedback during programming mode operations.
Describes the LED status for various base station operations.
Outlines the terms and conditions of the limited factory warranty for hardware products.
Details the steps required to obtain service under the factory warranty.
Lists conditions and situations not covered by the Datalogic Factory Warranty.
States that warranty rights cannot be assigned without Datalogic's consent.
Defines responsibility for product loss or damage during transit and possession.
Provides instructions for cleaning the scanner and base station exterior and contacts.
To Next Page