To Next Page
J
Jacob ThompsonAug 6, 2025
What to do if the Datalogic Barcode Reader LED is on but the barcode doesn't decode?
- JJeremy ChenAug 6, 2025
If the Datalogic Barcode Reader's LED is on but the barcode doesn't decode, it might be due to several reasons. First, verify that the imager is programmed to read the specific type of barcode you are scanning. Second, ensure the barcode label is readable and not damaged; you can also try scanning a different barcode. Finally, adjust the distance between the imager and the barcode, moving it either closer or further away.
General
