SCANNING FEATURES ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
55
Stand Mode/Object Detection Illumination Off Time
Specifies the amount of time reader illumination stays off after pulling the trigger when
in Stand Mode/Object Detection. The configurable range is 01 to 32 by 01 in increments
of 500ms (500ms to 16 seconds).
Set Illumination OFF Time
$CSNTM
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric charac-
ters in Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/
EXIT bar code.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
04 = Illumination OFF Time 2 second
To Next Page
Loading...
