Datalogic Quickscan QD2200

ENTER/EXIT PROGRAMMING MODE USB-COM INTERFACES
8 QUICKSCAN™ I QD2200
Disable Character
Specifies the value of the host command used to disable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
"Disable
Character" on page 153
for more detailed programming instructions.
Enable Character
Specifies the value of the host command used to enable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
"Enable
Character" on page 154
for more detailed programming instructions
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.
Select Disable Character Setting
$CR2DC
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL

0x44 = Disable Character is ‘D’
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.
Select Enable Character Setting
$CR2EC
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL

0x45 = Enable Character is ‘E’