Datalogic Quickscan QD2200

ENTER/EXIT PROGRAMMING MODE USB-COM INTERFACES
4 QUICKSCAN™ I QD2200
ACK NAK Options
This enables/disables the ability of the scanner to support the ACK/NAK protocol. When
configured, the scanner and/or host sends an “ACK” when it receives data properly, and
sends “NAK” when the data is in error.
Options are:
• Disable
• Enable for label transmission — The scanner expects an ACK/NAK response from
the host when a label is sent.
• Enable for host-command acknowledge — The scanner will respond with ACK/
NAK when the host sends a command.
• Enable for label transmission and host-command acknowledge

ACK/NAK Protocol = Disable ACK/NAK
$CR2AE00
$CR2AE01
ACK/NAK Protocol = Enable for label transmission
ACK/NAK Protocol = Enable for host-command
acknowledge
$CR2AE02
$CR2AE03
ACK/NAK Protocol = Enable for label transmission and
host command acknowledge