Datalogic SG2 BASE Series - Electrical Connections; Pin-Out and Configuration Pin Connection

SG2 BASE
29/68
4 ELECTRICAL CONNECTIONS
4.1 PIN-OUT AND CONFIGURATION PIN CONNECTION
All electrical connections to the emitting and receiving units are made through a male M12 connector, located on
the lower part of the two units.
For receiver a M12 5-poles connector is used, while for emitter a M12 4-poles connector is used.
RECEIVER (RX):
Fig 23 - Receiver
1 =
brown
= +24 VDC
2 =
white
= OSSD1
3 =
blue
= 0 V
4 =
black
= OSSD2
5 =
grey
= TEST/RESET
EMITTER (TX):
Fig 24 - Emitter
1 =
brown
= +24 VDC
2 =
white
= NOT USED
3 =
blue
= 0 V
4 =
black
= NOT USED
All manuals and user guides at all-guides.com