Datalogic SG2 BASE Series - 6 FUNCTIONS SETTING

SG2 BASE
34/68
The standard installation described hereinafter is the one shown in Fig 29 - page 33, i.e. with the bar assembled
with the connectors pointing down.
Two yellow LEDs ( LAST, SYNC), on receiver, facilitates the alignment procedure.
During standard operation, the LEDs indicate the safety light curtain status, as shown in the table.
FUNCTIONING STATUS
LED
colour
Symbol
Normal Status
NORMAL OP.
Stop Status
SAFE(BREAK)
Yellow
OFF
ON
OFF
OFF
Yellow
OFF
ON
ON
OFF
Red
OFF
ON
ON
ON
Green
ON
OFF
OFF
OFF
Standard
condition:
Not interrupted
beams
Units not aligned
Top side not
aligned
Highest beam
interrupted
Bottom side not
aligned
Lowest beam
interrupted
Units aligned,
but at least one of
beams (the highest
and lowest
excluded) is
interrupted
All manuals and user guides at all-guides.com