V110120E iBoot-G2 Page 19
11. Troubleshooting
The iBoot-G2 has a recessed pushbutton switch in the event the unit is not performing as expected. Use
the pushbutton as follows:
Action Result
Momentary Soft Reset. Will not change outlet status.
5 Seconds push Reset to Factory Defaults. Hold the button in
until the Outlet LED is blinking, then release.
Hold in while and
Power up the iBoot
Recovery Mode. Allows upload of new
firmware to Factory default IP Address
192.168.1.254
To Next Page
Loading...
Need help?
General
