iBoot Ver 1.5 Page 10
3. Setting the IP address using the ibootrst.exe
Dataprobe provides an iBoot Reset Program; ibootrst.exe to
easily reset the IP address, as well as set the factory defaults in
the event the security code is lost. Obtain ibootrst.exe from
Dataprobe’s web site. You can either download ibootrst.exe or
iboot.exe, which provides an iBoot control program as well.
For ibootrst.exe:
http://www.dataprobe.com/files/power/ibootrst.exe
For iboot.exe:
http://www.dataprobe.com/files/power/iboot.exe
To use ibootrst.exe, the computer running the program must be
on the same subnet and network segment as the iBoot is to be
programmed to. Same subnet can be directly connected or
connected through Ethernet hubs. (NOT routers or switches)
To use ibootrst.exe
Enter the MAC address found on the
underside of the iBoot and the desired
IP address. Click on the Set IP
Address bar. ibootrst.exe will confirm
the proper setting of the address. If
you receive an error message, check
the MAC and IP addresses.
Click the button for information about the utility program.
To Next Page
Loading...
Need help?
General
