Dataprobe iBoot User Manual

iBoot Ver 1.5 Page 9
iBoot Configuration
Setting I/P Address
Consult your Network Administrator to determine the appropriate
IP address. The IP address can be set in any of four ways:
1. Automatically from a DHCP Server
2. Web Browser via the Set-up Page
3. ibootrst.exe Program from Dataprobe
4. ARP / Ping
iBoot comes with factory installed IP address 192.168.1.254.
and ready to accept a new IP address from a DHCP Server. If
you network has a DHCP server, it will automatically assign an
IP address to iBoot the first time it is connected and powered up.
1. Setting the IP address from a DHCP Server
A DHCP server will automatically assign an IP address (dynamic
address) as well as Subnet Mask and Gateway to the iBoot. If
you power up iBoot without a fixed (static) IP address, the DHCP
server will be able to assign an IP address. This is the factory
default setting for iBoot. Once an IP address is assigned, you
must check the DHCP server to see what address is assigned to
iBoot.
If you set the IP address using another method, the address
becomes static. To return iBoot to dynamic addressing using
DHCP, change the IP address, using the web browser to 0.0.0.0
2. Setting the IP address using Web Browser
To set the IP address using a Web Browser, connect the
10/100Base-T connection to your local ethernet network and
apply power to iBoot.
Open your browser and access iBoot by entering the default
(192.168.1.254) or current IP address into your browser's
Address window. Enter the password (the factory default is
PASS). Click on Setup and follow the instructions on Page 14.

Dataprobe iBoot Specifications

General

Brand	Dataprobe
Model	iBoot
Category	Switch
Language	English