Datavideo DAC-2 - Front Panel Control; Front Panel Controls and Indicators

FRONT PANEL CONTROL
C-SYNC V
(
R-Y
)
U
(
B-Y
)
Y
Y.U.V. TO DV CONVERTER DAC-2
6
Select Analog Video input:
(Encode mode):
1. To select CV/S-Video or
YUV video input source
2. Hold down this button
and press on the “DV”
button to enable CV output
Color Bar Pattern video.
Press on the “DV” button
back to normal video out
Select DV input:
(Decode Mode)
Press on this button
to Reset the system
and select DV input
DV input indicator
“On” as DV input
Gen-Lock (C-sync) input:
1). Typical YUV input
2). YUV + C-Sync input
Y: U:V Input
There are three functions for this button (Please see Pa
ge
7 for more detailed instructions):
(NTSC MODELS ONLY)
Decode Mode: (DV input)
Mode 1 Default is the Windows 2000 mode
(This mode is primarily for Windows 2000 users.)
Pl
ease Note: The DAC-2 will alwa
y
s de
f
ault to this mode on power up.
Mode 2 is a secondary mode that works well with MACs
(running OS X) and windows
Mode 3 is a general setting for other DV devices (Cameras,
etc.)
Encode Mode: (DV output)
Press (Do Not Hold) to select 12-bit/32KHz or
16-bit/48KHz DV audio Encode mode
The 32KHz sampling rates is most commonly used for
DV camcorders and 48KHz is commonly used for
DVD as well as DV capture cards
Note: The DAC-2 will auto detect your audio decoding (exporting back
to tape) settings of your settings of your non-linear editing software.