11
• 1080p59.94
• 1080p60
FN5. Genlock Setting (Genlock Set)
This option enables/disables the genlock functionality and turns ON/OFF internal 75 Ohm
termination.
FN6. Genlock Status Display (Genlock Status)
Display current genlock status by returning values detected from sync signal.
FN7. Selection of SDI 3G Type (SDI 3G Type)
Enabling of 3G-SDI signal type on output ports (available modes are Type A and Type B).
FN8. HDMI Multiviewer Swap (Multi. Swap)
If Multi. Swap is set to ON, the multiviewer contents of the KMU-100 HDMI outputs will be
swapped.
FN9. SDI 4 Multiviewer (Multi. SDI)
If Multi.SDI is set to ON, the 4
th
SDI output of every output channel on the KMU-100 works as a
multiviewer output.
FN10. External Motion Trigger Setting (Trigger Set)
In this option, you will be able to configure the external motion trigger method. Motion 1-8 can be
controlled by an external device using the level trigger method. You can either set the trigger
method to low level trigger or high level trigger.
FN11. KMU-100 Firmware Version Display (KMU-100 Ver.)
Upon entering the KMU-100 Ver. Option, the KMU-100 firmware version will be displayed.
FN12. Display of KMU-100 FPGA and PCB Board Temperatures (KMU-100 Temp)
In the KMU-100 Temp option, you will be able to check measured temperatures of the KMU-100
FPGA and PCB boards.
FN13. RMC-185 Firmware Version Display (Firmware Ver.)
Upon entering the Firmware Ver. option, the RMC-185 firmware version will be displayed.
To Next Page
Loading...
Need help?
General
