NL Dateq BCS70 Manual BCS80 program director module 27
Pressing the “COM/MUTE”-button w ill initiate talkback from the program
director to the COM-bus.
Keypad
The monitor selection keys off er the program director the possibility to select
to w hich signal is monitored: AIR, SPARE1, SPARE2, COM, PGM, AUD, AUX or
CUE.
With the talkback keys the director is able to talk to the different talkback-
destinations: ANN (announcer), GST1, GST2 (the guests), the COM-bus, the CUE-
bus, DJ/CR (the discjockey or engineer), the STUDIO-output, or all destinations at
the same time (ALL).
The TEL1..TEL4 keys w ill sw itch the corresponding telephone hybrid on-line. This
is indicated w ith green LED’s in these keys. The telephone hybrids in the BCS70-
console w ill be numbered TEL1..TEL4 f rom lef t to right (TEL3 and TEL4 are optional
keys).
The OFF k e y sw itches the hybrid off-line. Green LED’s in these keys indicate that
the hybrid is off-line.
The MUTE key mutes the hybrid signal on-air.
By pressing the TALK key the director talks back to the corresponding hybrid.
This is done by sw itching the hybrid-return temporarily to the COM-bus, and letting
the director talk to that COM-bus.
To Next Page
Loading...