Datron neo - Page 14

2
Connecting the supply media
Cooling lubricant
2-6
DATRON AG Setup instructions neo
1.21
When machining non-ferrous metals, use the following cooling
lubricant for perfect operation and the best machining results:
Ethanol (99%, denatured)
Ethyl alcohol 642
EEC designation 200-578-6 (EINECS)
Ethanol can be purchased tax free without any formalities when
the following denaturants are involved: Methyl ethyl ketone,
shellac, pininic colophonium, toluol or cyclohexane.
Germany Austria
BCD Chemie GmbH
Frankfurt Office
Carl-Benz Strasse 4-6
D-60314 Frankfurt am Main
Tel.: +49 - (0) 69 - 40101 - 0
Fax.: +49 - (0) 69 - 425994
Frankfurt@bcd-chemie.de
LACTAN
Vertriebsgesellschaft m.b.H. & Co KG
c/o Mr Reibenschuh
Puchstrasse 85
A-8020 Graz
Tel.: +43 - (0) 316 - 23692 - 12
Fax.: +43 - (0) 316 - 323692 - 19
reinhard.reibenschuh@lactan.at
Tab. 2-1: Examples for ethanol suppliers
Impermissible cooling lubricants
Do not use any drilling emulsions, cooling lubricants with high
solid content or such which tend to flocculate (milky emulsion).
The DATRON machine is not designed for such cooling lubricants
and potential material damage could result. If this is not observed,
it will invalidate the warranty.
NOTE
Export restriction for initial filling of the machine with cooling
lubricant and coolant for spindle cooling unit.
DATRON machines are not filled with cooling lubricant when
exported to countries outside the European Union. In this case, the
customer must procure the suitable cooling lubricant.
Check your order confirmation.
DATRON approves the following products for use without
reservation:
•
Coolant for spindle cooling unit: Antifrogen-N with a water
content of 25 % - max. 27 %
•
cooling lubricant for workpiece machining ProCut 200,
ProCut 56 and ProCut 56-2
If in doubt, consult DATRON.