Datron neo - 2 Connecting the supply media; 2.1 Voltage supply

Connecting the supply media
Voltage supply
2
Setup instructions neo
1.21
DATRON AG
2-1
2 Connecting the supply media
CAUTION
Malfunctions and trip hazards
Open and loose machine connections are trip hazards and may
affect machine functions due to damage.
•
Avoid loose and open installations of machine connections.
•
Install machine connections in enclosed and fixed paths.
•
Position machines to enable optimum use of connection ports
in the machine housing.
Connection options
The machine can be connected from below, e.g. through a cable
duct in the floor.
2.1 Voltage supply
The power supply must meet the requirements of EN 60204 to
ensure trouble-free operation of the system.
CAUTION
Interference in domestic environments
The machine may generate electromagnetic interference, which
may affect electrical equipment in domestic environments.
■
If necessary, employ interference suppression measures in
accordance with DIN EN 61800-3
Information concerning personal
protection
■
If the power supply is fitted with a residual current device (RCD
or FI), the device must conform to type B.
■
The machine must be connected to a separate power circuit.
■
Other consumers must be separately connected.
■
Observe the local legal requirements for connection.
WARNING
Danger of injury and death due to high voltage!
Work on electrical devices requires technical knowledge, otherwise
there is a risk of injury and death by electrocution.
■
Electrical work must be performed by qualified electricians.