Maintenance M7/M7L/M7LT Modular Satellite Modem
3-108 M7/M7L/M7LT - Rev. 0.05
8. Set the < Mod: IF - AUPC Min Level> parameter to the desired level. Determine the value
for this parameter by calculating the minimum power that is allowed to prevent the link from
dropping below the operating threshold but should be several dB below the nominal operating
point for margin, e.g. -15.0 dBm.
3.10.3.1.6. Remote Site 3 AUPC PtMP Setup
1. Set the <Mod: IF AUPC Mode> to “Enabled”.
2. Set the <Demod: IF AUPC Remote Path> to “Disable”.
3. Set the <Intf: MCC Mode> parameter to “Full Access”.
4. Set the <Intf: MCC Send Rate Limit> parameter to “0.500 kbps” or higher.
5. Set the <Intf: MCC Send Address> and <Intf: MCC Rcv Address> parameters to “3” for
this example. The setting of this address can be any address between 1 and 254 but match
the <Demod: IF AUPC Remote MCC Address>parameter settings of the Dual Demodulator
B; Demod 1.
6. Set the < Mod: IF - AUPC Eb/No> to the desired value, e.g. 7.0 dB.
7. Set the < Mod: IF - AUPC Max Level> parameter to the desired level. Determine the value
for this parameter by calculating the maximum power that is allowed to prevent the link from
saturation but should be several dB above the nominal operating point for margin, e.g. -10.0
dBm.
8. Set the < Mod: IF - AUPC Min Level> parameter to the desired level. Determine the value
for this parameter by calculating the minimum power that is allowed to prevent the link from
dropping below the operating threshold but should be several dB below the nominal operating
point for margin, e.g. -15.0 dBm.
3.10.3.1.7. Remote Site 4 AUPC PtMP Setup
1. Set the <Mod: IF AUPC Mode> to “Enabled”.
2. Set the <Demod: IF AUPC Remote Path> to “Disable”.
3. Set the <Intf: MCC Mode> parameter to “Full Access”.
4. Set the <Intf: MCC Send Rate Limit> parameter to “0.500 kbps” or higher.
5. Set the <Intf: MCC Send Address> and <Intf: MCC Rcv Address> parameters to “4” for
this example. The setting of this address can be any address between 1 and 254 but match
the <Demod: IF AUPC Remote MCC Address>parameter settings of the Dual Demodulator
B; Demod 2.
6. Set the < Mod: IF - AUPC Eb/No> to the desired value, e.g. 7.0 dB.
7. Set the < Mod: IF - AUPC Max Level> parameter to the desired level. Determine the value
for this parameter by calculating the maximum power that is allowed to prevent the link from
saturation but should be several dB above the nominal operating point for margin, e.g. -10.0
dBm.
8. Set the < Mod: IF - AUPC Min Level> parameter to the desired level. Determine the value
for this parameter by calculating the minimum power that is allowed to prevent the link from
dropping below the operating threshold but should be several dB below the nominal operating
point for margin, e.g. -15.0 dBm.
To Next Page
Loading...
