EasyManuals Logo

Datum TYMSERVE 2000 User Manual

Default Icon
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
5.7 1 PPS OUT BNC (-GPS, -IRIG)
The 1 PPS output is a 200 ms wide pulse (rising edge on-time), generated by the TYMSERVE
and synchronized to the timing source.
5.8 FREQ OUT BNC (-GPS, -IRIG)
The frequency output signal is a TTL output set to either 1, 5, or 10 MHz. This output is
synchronized to the timing source.
5.9 PERIODIC OUT BNC (-GPS, -IRIG)
The periodic output signal is a TTL output whose rate is user programmable from 2.5 MHz to
less than 1 Hz.
5.10 1 PPS IN BNC (-GPS, -IRIG)
The 1 PPS input BNC accepts an external 1 PPS signal which can be used as the TYMSERVE's
timing source.
5.11 10 MHz IN BNC (-GPS, -IRIG)
The 10 MHz input BNC is not currently used.
5.12 SPARE1 AND SPARE2 BNC (-GPS, -IRIG)
Two spare BNC holes are provided for special applications which may require extra input/output
connectors.
5.13 GPS ANTENNA CONNECTOR (-GPS)
The GPS antenna connector is installed on the -GPS version only. This 15 pin high density 'D'
connector (male) carries the signals from the GPS antenna to the TYMSERVE.
5.14 CHANNEL 1 - 8 OUTPUT BNCs (-GPS, -IRIG with -TDM option)
The 8 BNCs labeled 'CH 1 OUT' through 'CH 8 OUT' are the 8 buffered time code outputs for
those systems equipped with the -TDM option only. The TIME CODE OUT BNC also carries
the time code output, but this output also drives the buffer's input, so if it gets shorted out then all
8 buffered outputs will be lost.
TYMSERVE 2000 Manual Datum Inc, Bancomm Div.
xxxii

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datum TYMSERVE 2000 and is the answer not in the manual?

Datum TYMSERVE 2000 Specifications

General IconGeneral
BrandDatum
ModelTYMSERVE 2000
CategoryServer
LanguageEnglish