TYMSERVE 2000
SYNTAX DisplayString (SIZE(0..15))
MAX-ACCESS read-write
STATUS current
DESCRIPTION "The variable is used to read or set the NIST
ACTS phone number. It is only valid on the
TS2000-ACTS. For more information on this
variable, refer to the TS2000 Users Manual. If
this variable is queried on the TS2000-GPS or
TS2000-IRIG it will return N/A."
::= {ts2Vars 11}
ts2NumberNTPRequests OBJECT-TYPE
SYNTAX INTEGER (0..32768)
MAX-ACCESS read-write
STATUS current
DESCRIPTION "This variable is a rollover counter which
reflects the number of ntp packets received
by the TS2000. It is valid for all versions
of the TS2000. The counter may be set to 0."
::= {ts2Vars 12}
END
C.2 ADDITIONAL STORED MIB VARIABLES
The first 16 characters of the sysName, sysContact and sysLocation will be stored in flash eprom
and load during any subsequent initialization or powerup. The only method of setting these
variables is to use SNMP set packets.
C.3 MIB COMPILATION
Most SNMP management platforms are capable of reading MIB-II data. The Datum specific
MIB extension needs to be added to the manager. Typically, these MIB extensions are defined
using a syntax known as ASN.1. The Datum MIB extension is provided on a DOS format floppy
disk and is defined using ASN.1. The user should consult their SNMP manager documentation
in order to determine how to compile the Datum MIB extension into their SNMP software
package.
C.4 SECURITY
Once the SNMP management software has been configured to recognize data from the TS2000,
the security parameters on the manager need to be defined to match those set on the TS2000.
These parameters are different dependent on whether SNMPv1 or SNMPv2 messages will be
sent.
Datum Inc, Bancomm Div. TYMSERVE 2000 Manual
xlvii
To Next Page
Loading...
General