Need help?Do you have a question about the Datum TYMSERVE 2000 and is the answer not in the manual?
Manual provides information on specs, installation, operation, and connectors.
Details the salient features of the TYMSERVE 2000, including time sources and protocols.
Overview of the TYMSERVE 2000 as a time server, its functions and capabilities.
Details the steps required to install the TYMSERVE 2000 Network Time Server.
Describes connecting the TYMSERVE 2000 to the network via the AUI connector.
Explains selecting and connecting an external timing source for the TYMSERVE 2000.
Instructions for positioning and connecting the GPS antenna for the TYMSERVE 2000.
Describes how the TYMSERVE 2000 accesses time data via Ethernet and IRIG B.
Covers basic operation, menu system use, and monitoring time synchronization.
Details compatibility with NTP versions 2 and 3 and host synchronization.
Explains the format of UTC time transmitted via the rear panel serial port.
Describes the format of the NTP message data area and its fields.
Overview of the menu system for setting parameters via front panel keyboard and LCD.
Details the components of the TYMSERVE 2000 front panel: LCD display and keyboard.
Instructions on how to enter and navigate the TYMSERVE 2000 menu system.
Guide to modifying network, timing, and feature parameters using the menu system.
How to view and save system information, including firmware version and configuration.
Explains how to save programmable parameters to EEPROM for retention during power loss.
Procedure for exiting the menu system and applying parameter changes.
Detailed description of network parameters like Internet Address, Subnet Mask, and SNMP settings.
Describes timing parameters for GPS and IRIG versions: Timing Source, Time Code Format, Current Year.
Details feature parameters for GPS/IRIG versions: Set time manually, Local Time Offset, Output Frequency.
Describes information found in the INFO area for GPS/IRIG versions: Firmware Version, VCXO Voltage, Satellite Usage.
Describes timing parameters for the -ACTS version: Make call to NIST, Call Reference Time, Call Interval.
Details feature parameters for the -ACTS version: Set time manually, Local Time UTC Offset, Modem Speaker Volume.
Describes information found in the INFO area for the -ACTS version: Firmware versions, Last Computer On/Off Time, Last Time Sync.
Overview of the input/output connectors located on the rear panel of the unit.
Details the Ethernet AUI connector for network connection.
Describes the RS-232 serial port connector and its pinout.
Information on RJ11 connectors, used for phone line connection on -ACTS version.
Details the AC power entry module, including power cord and fuse.
Describes the BNC connector for inputting time code signals.
Details BNC connectors for DCLS and modulated IRIG B time code output signals.
Describes the BNC connector for 1 PPS output signal.
Details the BNC connector for frequency output signals (1, 5, or 10 MHz).
Describes the BNC connector for programmable periodic output signals.
Describes the BNC connector for accepting an external 1 PPS input signal.
Notes that the 10 MHz input BNC is not currently used.
Mentions two spare BNC holes for special applications.
Details the GPS antenna connector for the -GPS version.
Describes 8 buffered time code output BNCs for systems with -TDM option.
Introduction to the troubleshooting guide for common problems and LRU replacement.
Troubleshooting guide for issues related to the timing source, e.g., 'FLY' display or incorrect time.
To Next Page
General