TYMSERVE 2000
the returned value will be N/A."
::= {ts2Vars 4}
ts2GPSUTCOffset OBJECT-TYPE
SYNTAX INTEGER (0..127)
MAX-ACCESS read-write
STATUS current
DESCRIPTION "This variable returns the current offset
between the monotonic time maintained by the
GPS satellite constellation and UTC time.
This value is commonly referred to as the leap
second count. It is only valid on the TS2000-GPS.
This value is obtained from the GPS receiver but
there may be a time lag between the incidence of
a leap second correction and the capture of that
correction by the TS2000-GPS. For this reason
the user is allowed to program the leap second
value which will be used until the TS2000-GPS
receives the leap second count from the GPS
satellite constellation. If this variable is
queried on the TS2000-IRIG or TS2000-ACTS the
value returned will be 0."
::= {ts2Vars 5}
ts2ForceACTSCall OBJECT-TYPE
SYNTAX INTEGER {
abort(0),
call(1)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION "The variable is used to either initiate a call
to the NIST ACTS service or abort a call that is
in progress. It is only valid on the TS2000-ACTS.
Reading this value will return abort(0) if offline
and call(1) if online.
Sending a set of this value to 0 or 1 will cause
the TS2000-ACTS to take the appropriate action."
::= {ts2Vars 6}
ts2CallRefTime OBJECT-TYPE
SYNTAX DisplayString (SIZE(0..10))
MAX-ACCESS read-write
STATUS current
DESCRIPTION "FORMAT: MM/DD/HH. All 8 digits are required
for set requests. Use \ or / as delimiters.
The variable is used to read or set the call
reference time. It is only valid on the
Datum Inc, Bancomm Div. TYMSERVE 2000 Manual
xlv
To Next Page
Loading...
General