2929
8008 TRS
8008 TRS
The Watt Individual Program / IL
The Speed Individual Program / Ir
This program allows the design of watt loading profiles individually suited to the user with maximum
duration as follows:
This program allows the design of training programs, with loading profiles related to the speed,
individually suited to the user with maximum duration as follows:
A braking power between 25 and 800 watt
can be preset for every single training minute.
Training with the Watt - Individual Program / IL
Training with the Speed Individual Program / Ir
If a Cool Down Program is selected and attached (see page 38), the training will automatically
proceed with it.
If a Cool Down Program is selected and attached (see page 38), the training will automatically
proceed with it.
A short melody is played when the program ends.
A short melody is played when the program ends.
Select user identification number (see page 5)
Put on the pulse sensor (see page 11)
Select the Watt Individual Programm / IL (see page 26 and 30)
“Standard selection steps 1 to 3”
Start pedaling to start the training session
Select user identification number (see page 5)
Put on the pulse sensor (see page 11)
Select the Speed Individual Programm / Ir (see page 26 and 30)
“Standard selection steps 1 to 3”
Create a new Velocity Individual Programm / Ir (see page 30)
Start pedaling to start the training session
The program keeps the travel speed at the value
preset in the program. Whenever the speed
increases to a value higher than the preset value
by more than 2 km/h, the braking power (watt) is
automatically increased by 5 watt/second. If it falls
below the preset value by more than 2 km/h, the
braking power (watt) is correspondingly reduced.
You can preset a speed value between 5 and
99 km/h for every single minute of the training session.
User 1
User 2
User 3
User 4
60 minutes
60 minutes
60 minutes
240 minutes
Model
User 1
User 2
User 3
User 4
60 minutes
60 minutes
60 minutes
240 minutes
Model
Individual Program P
Training Programs