2
)
)
)
SLP
watt
2
Power cord
Upon turning on the power switch (On/Off),
the six display windows of the dashboard
will display all the symbols and number
segments for about eight seconds. This is
a self test run by the computer on the entire system.
The ergo_bike switches automatically to stand by mode if it is left switched on and
unused for about two hours. This is signaled by three beep sounds and ten times blinking
of all the windows, and by the display of “SLP” in window number 2. All other windows
are blanked. This mode is terminated by pressing control button number 6.
The graphic display (window no. 6) provides for more
functional and visual convenience. Displaying training
diagrams, user guidance and hints are functions that
can only be displayed on a graphic display.
Window no. 6
LCD Graphic Display
See page L1 for
explanation about
the display
The dashboard of the “8008 TRSi” shows
a Graphic LCD in its center (see page 4). You will find
a special description of this equipment part and
its operation in appendix L (LCD Grafic Display).
General information
Setting up
Switching On / Off
Please read the Notes on Safety (page 19)
before switching the ergo_bike on, and follow
the installation and assembly instructions
(pages M1 - M15).
The On/Off switch (power switch) is located
at the back in a rectangular plastic frame on
the rear perforated plate cover.
On / Off
The ergo_bike should be switched off by mean of the
On/Off switch or by pulling the power cord plug
from the power outlet.
(This does not apply for the values of the “guest” user.)
Always press the Reset key before switching the
device off in order to save the distance covered
in kilometers.
“Stand-By mode” ( SLP )
Display-
window
Window no. 2
Please note:
The value of the daily kilometer counter (the wide arrow pointing to Distance) will
always be added to the total kilometer counter (the arrow pointing to User/Km Total),
1. if the ergo_bike goes in Stand By mode ( SLP-Mode ).
2. or if the Reset key is pressed,
or when
3. another person starts a session and another user identification number is selected.
To Next Page
