3
Comparing Before You Save
Before saving the edited program, it’s a good idea to listen to the program in the
target location to make sure you really want to overwrite it.
To evaluate a program before you overwrite it:
1. Get ready to save by pressing the write button. It starts ashing.
2. Press the compare button. Its LED lights up.
3. Use the bank and program knobs to navigate to the sound you want to
compare and play the keyboard to hear the sound.
4. To disable the compare function and go back to the edited sound, press the
compare button again to turn it off. (Programs can’t be written while in
compare mode.)
5. If you want to save the edited sound, the write button is still ashing and
ready to save, so navigate to a location with the bank and program knobs
and press write. The sound is saved.
Alternatively, if you want to cancel saving and continue editing, press the global
button. Saving is canceled.
Saving an Edited Program
To save the edited program to the same preset location:
1. Press the write button. Its LED begins blinking.
2. Press the write button again. Its LED stops blinking and the program is
saved.
To save a program to a different location:
1. Press the write button. Its LED begins blinking.
2. Turn the bank or program knobs to select a new location. You can only save
to banks U1-U4.
3. Press the write button again. Its LED stops blinking and the program is
saved.
Saving a program saves any edits to programs on both Layer A and Layer B.
To Previous Page
Loading...
