17
MCS System
At any point during this sequence, the audible chirp or alarm can be deferred for
sevendaysbyholdingthecontrollerbuttondownforaperiodofveseconds.The
number of deferrals used will be displayed as below. Once the deferral expires,
the alarm will sound once again. The de-ferral can be repeated up to three times.
PLEASE NOTE: At any point after lamp expiration, the water may be unsafe for
consumption and should not be consumed without another form of disinfection.
MCXS System
Lamp Replacement (MCS systems)
After the lamp is expired, it must be replaced with the same part number as indicated
by the label on the reactor. Begin replacing the lamp by unplugging the power for the
controller, then refer to Installation, starting with step 11 (page 11) for instructions on
installingthenewlamp.Toresetthetimerinthecontroller,rmlyholddownthebutton
onthecontrollerfor10seconds.Thecontrollerwillread“rSt3”,“rSt2”,“rSt1”andthen
beep. The button can now be released, the lamp countdown timer has been reset.
Lamp Replacement (MCXS systems)
After the lamp is expired, it must be replaced with the same part number as
indicated on the Maintenance Parts screen or on the label on the reactor. With
the system powered down, re-move and discard the lamp key from the controller.
The replacement lamp is packaged with a lamp key on the connector at the end
of the lamp. Remove the key from the lamp and place it in the controller. Refer to
Installation, starting with step 11 (page 11) for instructions on installing the new lamp.
QR Codes
A QR code(QuickResponsecode)isamatrixbarcoderstdesigned
for the automotive industry. Microlene uses the QR code to store a
linktoaspe-cicpageonourwebsite.Userswithacameraphone
equipped with the correct reader application can scan the image of
the QR code and over a wireless network connect to a Microlene
web page in the phone’s browser. Microlene’s QR webpage has
information on how to purchase replacement components as well as
a helpful video directory on system servicing (i.e. How to change a UV lamp or quartz
sleeve). To access the QR code on the Mi-crolene controller, press the control button
until the QR code screen appears.
To Next Page
Loading...
Need help?
General
