22 15
pump prior to connection of the pump
®
can cause an air lock
that may prevent the pump operating
properly.
The following sections of the Type
1 installation instructions are
applicable to Type 2 installations.
Step 2 – Work out the position of your
®
with regard to distance to
issue here.
Step 4
®
for easy
fitting to the plumbing and fit Davey wall
bracket if required.
Step 5
®
to your
submersible pump as per instructions on
page 25.
Step 6
®
to the
page 19.
Step 7
submersible pump.
Step 8
INSTALLATION TYPE 3
IMPORTANT
collecting/storing rainwater in a
partially buried tank is considered
®
to fit additional
valves to satisfy this requirement –
check with your local council as to
their guidelines on rainwater tank
switch as this comes attached to the
submersible pump and does not plug
®
unit.
TO TOILETS
AND/OR
LAUNDRY
(do not mix/cross-connect
with mains water supply)
MAINS
WATER SUPPLY
3/4" BSP M
RAINWATER
SUPPLY
from discharge
of auto submersible
rainwater pump
Power to pump via
3 pin socket - plug the
rainwater pump in here.
Incoming power
to RainBank
®
via 3 pin plug
3/4" BSP M
1" BSP M
Stop valve
200 Micron
‘Y’ Strainer
* Pressure Limiting Valve
WHERE MAINS PRESSURE EXCEEDS 900kPa.
A PLV* MUST BE FITTED TO INLET!
To Next Page
Loading...
