®
or
its pump we strongly recommend the use
of a suitable surge protection device and
residual current devices.
STEP 8 - TESTING
®
.
1. With the mains connected and the
rainwater tank empty turn on one
of the taps in the laundry that feed
not turn
‘status’ light should glow
‘red’ to indicate that mains water is
being used. When this is completed
turn off tap.
2. Fill the rainwater tank with sufficient
switch.
primed and there are no air locks that
will interfere with its operation as per
essential for the proper operation of
to do this for all types of Davey pump
should run and deliver rainwater.
‘status’ light
will now glow ‘green’.
®
– this should
stop the pump and confirms that
connections have been made correctly
‘status’ light will now glow ‘red’.
‘status’ light will glow ‘yellow’
while the manual override button is
depressed.
®
models.
®
, the
pump, pipework and fittings.
INSTALLATION TYPE 2
Above ground tank with submersible
pump inside eg: KRBS1&2
IMPORTANT
level so it is not necessary to drill the
16 21
INSTALLATION TYPE 1
Above ground tank and pump
outside tank. Suitable kit models:
KRB1,2,3&4
®
to a wall as a bare installation you
®
wall
mounting bracket
STEP 1 - PUMP POSITION
of the tank to avoid sludge being drawn
into the pump.
STEP 2 - RAINBANK
®
POSITION
®
will be
positioned.
reach of the 3 metre power lead.
IMPORTANT
leads as they cause substantial voltage
drop, poor performance and can lead to
motor overload.
®
.
Mains In
To House
FS
Installation Inside Buildings
cater for possible plumbing leaks or damage
®
system components, the
installation must include an enclosure that will
capture any water spraying from the plumbing
®
system and direct it into a
properly constructed drain tray.
Note
®
and/or associated pump system inside a
building, allowance for possible high pressure
Note
®
accessible to the end user or home owner.
To Next Page
Loading...
