Selecting Units of Measure
21
Humidity
Press HUM to select outside humidity. Pressing HUM a second time
selects inside humidity. Humidity is displayed in percent relative humidity.
Each consecutive press of HUM displays humidity readings for any optional
humidity, leaf wetness, and leaf temperature stations also connected to your
console. The order of the optional sensors readings display depends on your
station configuration. Humidity readings for humidity stations display, with
leaf wetness and leaf temperature readings displaying consecutively.
Wind Chill
Press 2ND then press CHILL to select Wind Chill. Wind
Chill is displayed in either Fahrenheit (ºF) or Celsius (ºC) in
whole degrees.
The console uses the ten-minute average wind speed to calculate wind chill.
Dew Point
Press 2ND then press DEW to select Dew Point. Dew Point
is displayed in either Fahrenheit (ºF) or Celsius (ºC) in whole
degrees.
Barometric Pressure
Press BAR to select barometric pressure. Barometric pressure may be
displayed in inches (in), millimeters (mm), millibars (mb) or hectoPascals
(hPa).
Pressure Trend
The pressure trend arrow indicates the current barometric trend, mea-
sured over the last three hours. The pressure trend is updated every 15
minutes. The pressure trend requires three hours of data in order to be
calculated so it won’t display right away on a new station. The pressure trend
is indicated on the console screen, as long as the required data is available.
To Next Page
Loading...
Need help?
General
