04
Please install and adjust the machine according to the requirements of the manual.
It is very important for your safety and correct operation.
Unpacking
Unpack the carton and take out the bottom panel.
Open the top lid of washing machine and take out all the accessories.
Remove all wrappers, including the polystyrene base.
You are advised to keep all the packaging for reuse, in case the machine is to be
transported again.
Installation and adjustment
Before using
Installing the bottom cover
Fixing clamp
Scissors
Bottom cover
The base
Loosen
Fasten
Adjustable
nut
Adjustable
foot
High Low
Positioning
The distance between the washing machine and the wall should be more than 50mm and the
maximum allowed angle of the shank base of the machine is 1 . The slanting or rough ground may
cause unstability or the operation to stop. Please adjust it with the following methods:
Horizontal checking
is in red circle or not. In red circle, it is horizontal.
Adjust the adjustable foot
1.
and twist the adjustable foot.
2. Fasten the nut after adjustment.
3.
is not in red circle,
bubble is in red circle.
Lift up the adjustable foot gently. Now loosen the adjustable nut
repeat the above procedure till the water
2
Observe, if the water bubble in balancing apparatus
Set the machine at and observe again. If the water bubble
To x bottom cover, rst cut the clamps on the
cover and insert the cover in slots present at bottom
in the direction mentioned in picture. Place two
screws at the bottom in the present slot to
permanently x it.
2
04
To Next Page
Loading...
Need help?
General
