Maintenance
Operation
1.Once you have used the machine, you are advised to turn off the water tap. (If necessary, pull out
the inlet hose).
2. Do not keep the water in tub for a long time. When washing is nished, drain it right away.
3. Once you have nished using the machine, you are advised to unplug it.
4. Put the electric cable and the drain hose in order.
5. Wipe the water on the surface and in tub with a soft cloth and keep the top lid open for a while. It
helps prevent mould and stagnant smells from forming inside the appliance.
The machine will stop automatically and the
buzzer will remind you to take out the laundry
or start again.
Once you have nished using the machine,
you are advised to unplug it and turn off the
water tap to avoid unexpected leak or re.
After the end of the programme
Clean the exterior cabinet of the appliance with a
soft cloth. Do not use cleanser or volatile chemical
materials to clean the machine. These will
damage plastic parts and the surface of the machine.
External cleaning
Clean inlet gate
It is possible that the inlet lter net can be blocked
by the dust. Please clean it according to the
following steps:
1. Close th
e tap and turn on the power switch.
2. Start the washing machine for 5 seconds (let
the water in the inlet hose ow to the tub), and
cut off the power supply.
3. Pull off the inlet hose, remove and clean the
inlet valve and the inlet net, and install again.
Maintenance methods
If the water in the inner tub has possibility to freeze, please do like below:
1. In winter, if the remaining water freezes, it can cause the washing machine trouble.
Please take off the water inlet hose and drain out the water from the hose and inner tub.
2. If the water freezes, please don't operate the washing machine. Put 40
o
C hot water
in the tub. The hot water should submerge the pulsator. After a few minutes, rotate
the pulsator by hand gently. Now, you can operate the washing machine.
Magic lter cleaning
1. Pull out the magic lter.
2. Open the box and clean it.
3. Close it and reinstall it.
4. Check if the lint block part is in good condition.
(press and pull to take the magic lter out.)
lint block part (black rubber)
14
14
To Next Page
Loading...
Need help?
General
